| |
5 of 5 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerFrederick from Scottsdale AZ
Microwave turntable would not turn
Turned off circuit breaker to microwave. (Built-In microwave). Unscrewed four screws at bottom panel of microwave to expose electrical wires/plastic plug to existing microwave motor.
Disconnected plastic plug/clips to motor and microwave lights(to allow entire bottom panel to drop down fully from back hinges). Unscrewed mounting screw for motor and removed old motor. Replaced motor and screwed mounting screw back in. Re-attached electrical connections for motor and lights. Closed panel and screwed bottom panel back on. Turned circuit breaker back on. 15-20 minutes start to finish.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customerkevin from navarre FL
Turn table was intermintant
The motor would turn about 10 revolutions then quit. I would manually spin the motor and it would turn about another 10 revs and quit again. The motor I ordered was an exact match OEM and install time was less than 30 min total to install the motor, secure the electrical and the bottom of the microwave. Thanks Partselect for the prompt delivery and ease of using your web sight.
|
2 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerGlen from Lebanon TN
Turn table inop.
first removed four screws lower panel, one motor screw,electrical connector, and reversed procedure done. To add a little to this repair story, we had a recall on our maytag dish washer, asked if at the same time they could bring a motor out for microwave, they said no without diag. time, also told them I'd pay for install, even if my diag. was wrong, and the part also, there lose! Thank you all having the correct parts at a very reasonable price.
|