| |
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerDavid from Fredericksburg PA
Broken inner and outer handle
1. Open Door
2. Use Putty Knife and and carefully separate outer door frame from inner door frame
by sliding the putty knife all the way around the frame from the inside
3. Remove the old broken handle. You should use a pointy nose pliers to take hold of the
handle screws once you have then loose...
4. Install new handle, Make sure it is seated flush in the door frame, then tighten with
two screws (use the pointy nose pliers to get them started . .very tight space to work in)
5. Snap on outer frame.
6. Your done!
Dave
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerRuth from New Bloomfield MO
Microwave handle was completely broken off
Found info on how to replace handle here. Couldn't have done it without that information! We popped out the black trim on the inside of the door and removed the spring to access the bottom screw. From there it was pretty much easy to see where ever thing fit. Had difficulty getting the tabs clipped in the front of the door.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:More than 2 hours
ToolsScrew drivers
CustomerBonnie G from Port Townsend WA
Microwave door handle broke
I received the door handle in 2 pieces along with one screw to put the two together. 3 days later the 2 screws to attach the handle to the microwave door showed up so I could finally put the handle on. I was amazed that I had to purchase each piece separately and that they pieces were shipped in two deliveries.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerJoseph from Bridgewater NJ
Handle broke off original microwave door
Separated the inside panel on the microwave door, removed the screws from the old door handle and utilized them to install new door handle. Access to the screws was a little tight thus the "a bit difficult" rating.
|