2 of 2 people found this instruction helpful
Level of Difficulty: Very Difficult
Time to do repair: More than 2 hours
Tools: Screw drivers
Customer: Ulises from Bellevue, ID
Dryer wouldn't start
The part didnt line up with the timer markers.
Instructions said where toscrewed it to the machines but didn't match the on and off buttons.
Rotated it and it fit a little better but it still didn't match the minutes or on and/off for every section.
Had to drill a hole in it to screw it in as well cause the ones that came drilled were not lined up right.
1 of 4 people found this instruction helpful
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers, Socket set
Customer: Dennis from Meriden, CT
Sparks came from the timer
Unpluged the dryer and removed the rear cover to get access to the timer. Removed the control panel and unscrewed the timer leaving the wires connected. One by one connected the wires to the new timer along with the resistor. Secured the timer to the control panel and attached the control panel and rear cover. If you have enough room you do not have to remove the control panel.
The dryer works great.