2047350-1-S-Whirlpool-52085-29-Defrost Thermostat
2047350-1-S-Whirlpool-52085-29-Defrost Thermostat 2047350-2-S-Whirlpool-52085-29-Defrost Thermostat 2047350-3-S-Whirlpool-52085-29-Defrost Thermostat

Defrost Thermostat

PartSelect Number PS2047350

This thermostat will cut out at 40 degrees Fahrenheit and kick back when the temperature drops to 25 degrees Fahrenheit.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Fridge too warm.
  • Freezer section too warm.
  • Compare At

    $36.24
  • You Save

    $6.04
  • Your Price

    $30.20
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.9 / 5.0, 4 reviews What's this?
1-4 of 4
 

57 of 61 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsNutdriver, Pliers

CustomerJohn from Matthews NC

The freezer was cold but refrigerator was warm

This is a problem in the defrost cycle. It is one of three items the heater, timer or thermostat.. I removed the screws from the back side of the freezer and romoved the sheet metal from the back which exposes all the elements. Below the evaporaro coils are two small plates which cover the heating elements ( two glass tubes conected to insulated wire), You may be able to look at it and tell if they are bad. Mine was burnt and obviously gone. If you disconnect from conectors you can check for conitinuity to tell if bad. Simply remove the four screws holding these in place and install new one the same way. quite easy. I did check the thermostat for continuity and relaced it also. It simply plugs into a clip on the back wall and two power connectors. If checking themostat for continuity make sure it is cold otherwise it will be open and you won't get a good read. The timer for this model is under \neather behind the grill on the bottom. simply turn the dial and if the motor stops it is probbably good. It runs 8 hr. and then will shut off for defrost heater to come on. Do this before closing up to tell that your new heater is working. It will get red quickly. Saved a lot of money on this one

Help other customers find the most helpful instructions.

Were these instructions helpful?

17 of 20 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers

CustomerThomas from Cornelius NC

Defrost heaters burned-out

Defrosted, removed old heaters and thermostat and installed new heaters and thermostat. Not a hard job at all.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 13 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver, Pliers, Screw drivers

Customerpierre from SEPT-ILES AL

The coils was all frosted the frid di.Nt get cool

I put the frig a off on the knob in the grig took the plate on the back in the unit check for no power disconnect the 2 wires for the heating element tie up a little rope that I will use the pull the new wire. took off the plate and the heater take off the old heater ,install the new one on the plate and rinstall every thing in place, turne the defrost time and chech if the heater was woking to do so I had the turn the thermostat at :E: the compressor stop and the heater come on. reintall the plate the selfs,When il checked the heater I check the thermostat of the defroster becaese it when off and the heater cut off Put back all the food and open a nice big bottle of beer ````Excuse my english I know is not too good

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 3 people found this instruction helpful

Parts Used

  • Defrost Thermostat

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerWalt from Sutter CA

Evaporator coils would freeze up solid

Removed everything from inside freezer compartment (food and shelves) Removed inside backpanel that covered the coils. At the top of the coils is where the thermostat was attached. Removed old one and installed new. Has been working since.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4