2040223-1-S-Whirlpool-38359-Tub Cover Gasket - Large
2040223-1-S-Whirlpool-38359-Tub Cover Gasket - Large 2040223-2-S-Whirlpool-38359-Tub Cover Gasket - Large

Tub Cover Gasket - Large

PartSelect Number PS2040223

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

COVER, OUTER TUB

Part Number 2039914

$44.43
No Longer Available

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.0 / 5.0, 1 reviews What's this?
1-1 of 1
 

45 of 49 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)

CustomerGary from Dousman WI

Noisy during spin cycle

This was the second time for the repair. The original bearing lasted 5 years then became noisy. Replaced it, and the unit worked great 5 more years and the noise came back. So I knew exactly what needed fixing what to order, parts wise. This is not a project for the faint of heart, you will completely disassemble your washer to change out the main bearing. Roughly here are the steps: 1, pull out the agitator with a good firm jerk up. 2, remove the rubber plug in the center of the drive hub, 3 remove the bolt you have just exposed. 4, pry up on the hub, use a puller if you have to to remove it. 5, pry off the cone shaped rubber seal and remove the large main nut from the drive shaft. 6, remove the 4 bolts holding tub, 7 remove the front panel and unscrew the front of the top panel, tip the top up. 8, lift out the tub, 9, remove the 6 large springs holdig the inner assembly to the base, 10, disconnect the water to tank hose and the fill level hose, 11, disconnect the motor cable at the motor, 12, free up the drain hose and pull it, 13, have a helper lift the inner assembly out and move it to a work area, 14, unbolt the drum from the base, motor, and counter weight 15, pry the drive hub off the transmission shaft, 16, remove the rubber seal from the drum, 17 flip the drum and remove the 3 bolts holding the bearing in place. Reverse to put it back. These steps are from memory so they may not be exact. The exploded views on PartsSelect.com web help, as to the instructions that come with the parts.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1