| |
11 of 14 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers, Wrench set
CustomerBryant from Round Lake IL
Dryer would heat up initially, but then turn off and not restart
I did reseach online and the first thing they told you to check were the thermostats and the thermal fuse, so I ordered those parts. I took the dryer apart, found the parts and tested them with my ohm meter and they all tested fine. I should have tested them initially before ordering them. Then I did more research and found out that if the thermostats are fine, it is more than likely the Coil Valves and there are 2. I also learned that you can test these parts and they may test correctly, but they will test differently when they are hot versues cold. I seemed confident that these would do the trick. I ordered the parts and replaced them, which was very easy to do. Then I put the dryer back together, started it and it worked perfectly!!!
PartSelect website was very help and I received the parts very quickly. I'm returning the parts that were not used for a refund.
|
11 of 22 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerKenneth from Philadelphia PA
Timer not working and thermal fuse
|
4 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsNutdriver
CustomerLaurence from Chino CA
Dryer turned on and ran but no heat
I watched your video on your website first and followed the simple instructions. I completed the repair in 40 minutes. Works like it was brand new....
|
0 of 4 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerDaniel from Edgewood MD
Flame would stay on for a few minutes and then go out
Jumped out both limits and flame would still go out, grab the 2 plug gas valve solenoid and it would click and the flame glow coil would start back up. I ordered both solenoid valves and the flame would stay on longer but not like it used to. On time drying the flame should stay on all the way thru the cycle unless it got to hot and the cycling stat would take over. Ordered a cycling stat and now it heats like it used to. The clothes are hot now when they come out. If you jump out the limits and still the flame doesn't stay on like it used to, replace the gas valve solenoids and the cycling stat.
|