2038665-1-S-Whirlpool-35229-Timer - 4 Cycle
2038665-1-S-Whirlpool-35229-Timer - 4 Cycle 2038665-2-S-Whirlpool-35229-Timer - 4 Cycle 2038665-3-S-Whirlpool-35229-Timer - 4 Cycle

Timer - 4 Cycle

PartSelect Number PS2038665

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 2 reviews What's this?
1-2 of 2
 

4 of 7 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers, Wrench(Adjustable)

CustomerGeorge from Grove City PA

The washer was taking a long time to fill and would run through multiple cycles

Removed old timer replaced new.
Removed old water inlet and replace with new. I don't think that the water inlet valve had anything wrong with it. But I had one go on me before and thought that It may be the cause of the filling problem. We thought it was taking forever to fill, when actually it was just running through all of the cycles.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Timer - 4 Cycle

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers, Socket set

CustomerDan from Blue Grass IA

Timer would not run end spin after rinse cycle.

Unplug the washer from the outlet. Remove two screws holding top of control panel and remove. Fold control panel forward as far as it will go, but don't force it. Remove 4 screws holding back panel down to washer, this gives adequate space to access the timer. Unscrew the knob from the front counterclockwise. Pull timer faceplate located under the knob straight off gently. Remove the two screws, (one on top, one on bottom), holding the timer to the control panel. Pull it out far enough to get a firm grip on the wire lead and disconnect it from the timer. Install the new timer unit in reverse procedure. When reinstalling the timer faceplate, notice that it only fits on one way. Look for, and match up the flat edges as you push it on. Be sure to rotate the timer to the top position before plugging it back in. For most of the work I used a phillips head screwdriver, flat head screwdriver, 1/4 in socket with a 1/4 in drive and extension. I am pleased with the operation and price of this timer unit!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2