Water Valve

PartSelect Number PS2037181

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Will not stop filling with water.
  • Leaking.
  • Compare At

    $79.51
  • You Save

    $13.25
  • Your Price

    $66.26
In Stock
Order within the next 6 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 2 reviews What's this?
1-2 of 2
 

24 of 32 people found this instruction helpful

Parts Used

  • Water Valve

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerJames from Promont TX

The cold water would not shut off. (many diff. Error codes)

1. Unplug the machine. Take off the cold water line from the machine.
2. Take out the two screws from top back to remove top.
3. Unplug the three electrical connectios from the valve sylenoids.
4. Take off the two screws that hold the three way valve to the machine back.
5. Unclamp the three clamps and remove the hoses from the valve end.
6. Place the hoses and clamps on the new valve.
7. Reincert the three electrical connectioins.
8. Secure valve in place with the two screws from above step 4.
9. Replace top and secure with two screws from step 2.
10. Connect cold water line. Plug machine in.
11. Done.

PS. There is a diagram of the connections on top of the distribution center.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 7 people found this instruction helpful

Parts Used

  • Water Valve

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers, Screw drivers

CustomerRobert from Monticello GA

Because of sand in my well water,the valve quit working properly and water would run constantly

I removed two screws on the back of the washer,removed the top of the washer unclipped three plastic wiring clips, removed two screws holding the valve in place.replaced valve and replaced wires and top of washer. Total time about 15 minutes

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2