4 of 9 people found this instruction helpful
- Control Panel with Touch Pad
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
CustomerMichael from Merritt Island, FL
Dryer would not start and would beep 3 times when plugged into wall.
I disconnected the membrane from the control board and when I would plug it back in the board would beep 3 times, then it would beep randomly and the same lights always came on. I determined that the membrane might have gone bad, bad button etc.
Part came in, removed back panel, control board from the back of console and slide console off. Installed new console w/membrane, attached control board and this did the trick, Dryer works again with no more problems.