http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/53130.gif
See part 17 in the diagram

Wire Harness

PartSelect Number PS2036278

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $62.02
  • You Save

    $10.34
  • Your Price

    $51.68
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 1 reviews What's this?
1-1 of 1
 

3 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers

CustomerConstante from Antioch CA

Burnt control board particularly the heatin element and motor relays.

Unplug dryer cord!!!

Loosen and removed screws (phillips and hex head) at the back of the console(display). This allows for the removal of the console. Remove control board and replace with new part.

The harness wiring is easier installed with the drum removed; 1. Remove dryer lid by taking out 2 screws securing the hinges. 2. Remove 2 screws at the left side to allow removal of the front panel. (Note that there are wirings in the front panel, so it is best to just set the panel close by for rewiring) 3. This expose the 3/8" hex screws securing the hook holding the top panel. Remove screws and lift top panel for removal. 4. Loosen drum belt with the idler and remove drum for easier access to the wirings. 5. Remove old harness and install the new replacement part placing corresponding terminal as the old ones are removed. (Note that the old harness can be completely stripped out then run the new harness-for the experts).

While the heating elements and the motor are accessible, check with the multimeter to make sure none is grounded or shorted (remember the condition of the control board may have been caused by high current flow).

Replace the drum and set the belt. Install top panel with the retainer hook. Install front panel and the dryer lid.

Plug the dryer cord and run the appliance. Good job!

Comment: The original control may have a design flaw (relay contact rating) as the components that draw higher amps(current) are fine yet the contacts including the wiring terminations were melted. Do you know if there was a recall on this product? It almost caused a fire...

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1