| |
7 of 10 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerJerry from Las Vegas NV
Timer assembly would not advance
Removed old timer assembly, put the new one next to it and as I disconnected one wire from the old part, I connected it to the new part, that way I was able to connect each wire to the right place.
It was very easy.
|
3 of 4 people found this instruction helpful
Parts Used
-
- Timer - with chiming mechanism
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers, Wrench set
CustomerRichard from Keswick VA
Dryer timer dial was cracked and thus would not turn the timer pivot.
Ordered the three pieces of the dryer dial and replaced the old dial with the new one.
|
2 of 3 people found this instruction helpful
Parts Used
-
- Timer - with chiming mechanism
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
CustomerRandall from Viper KY
Dry er would run but no heat.
Appliance dealer stated that usually timers did not go out and thermostats were most likely . Tried all and called repairman that did not show. Removed cover found burned gear in timer ordered. The part is easy to replace just change wires one at a time or take a digital pic of the wires.
|
2 of 4 people found this instruction helpful
Parts Used
-
- Timer - with chiming mechanism
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers, Screw drivers
CustomerWalter from Flagstaff AZ
Timer quit working after lighting strike
remove back cover 3 screws, change wires in same order as old timer, remove two mounting screws under timer dial, check voltage-replace temp sending control attached to brown wire.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Timer - with chiming mechanism
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers, Screw drivers
CustomerDick from Alexandria VA
Dryer wouldn't shut off.
Had the dubious distindtion of having two switches (start switch & the timer) go bad within 3 months of each other. The start switch has been previously discussed.
The access plate to the controls is secured be 3 phillips head screws and 2 nut-driver bolts.
The switch itself is secured from the front of the machine be two phillips head screws, located underneath the knob which is easily pulled off.
Just replace the wires one-by-one using needle nose pliers on the clips .
A real no-brainer.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Timer - with chiming mechanism
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers, Screw drivers
CustomerBarry from Hollywood FL
Dryer wouldn't stop automatically
Removed the knob. Removed back panel. Removed the timer (2 screws). Pulled off wires and put them on the exact same spot on new timer. Attached new timer and replaced panel. Dried my cloths to perfection! (While I took a nap)
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver
CustomerRobert from Ray ND
The dryer would not shut off. The timer would not advance,
I replaced the timer and timer dial skirt which was very easy to repair. The dryer would not shut off and the timer would not advance. I could manually use a plier to move the timer and it would shut off then. I replaced the timer and it works well now.
|