5 of 8 people found this instruction helpful
Level of DifficultyReally Easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerBRYAN from NORTHAMPTON, PA
Verified timer as faulty with use of schematic and ohmmeter, Element, motor switch, and thermostats within specs, no continuity on pink/black timer leads on any cycle.
First remove the back cover consisting of three phillips screws and two 1/4" hex head sheet metal screws. Then pull timer knob straight off and subsequently remove the two 1/4 " hex head self-tapping machine screws. Then remove each spade terminal, one at a time, connecting them to the terminals on the new timer. Note- the timer has the wire colors imprinted on the body if you do not replace one at a time.
Reverse the above procedure for assembly, noting the position of the timer knob will align with the "keyed" shaft.