Quick Question!

Have you ever purchased from PartSelect.com before?

2035275-1-S-Whirlpool-33001228-Temperature Switch
2035275-1-S-Whirlpool-33001228-Temperature Switch 2035275-2-S-Whirlpool-33001228-Temperature Switch 2035275-3-S-Whirlpool-33001228-Temperature Switch http://www.partselect.com/Schematics/Maytag/35554.gif

Temperature Switch

PartSelect Number PS2035275

This is a 3 position temperature switch.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At

$34.10

You Save

$5.68

Your Price

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.8 / 5.0, 3 reviews What's this?
1-3 of 3
 

11 of 16 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers
Customer: Jason from Miramar, FL

Temperature knobs broke off washer and dryer

First I removed the four screws on the top of the panels of each appliance. The panel covering swings/rotates forward and then allows you take them completely off. Next I located the switch and removed each push-on connector being sure to immediately attach it to the correspoinding connector on the new part. When all wires are connected re-seat the switch and re-attach the panel enclosure. Replace the screws on the top of the panels. The stems for the switches should be showing through the panel and then replace the knobs. Done!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

3 of 6 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers
Customer: WALTER from SANTA MONICA, CA

Snapped knob stem off temperature selector switch

unplugged dryer. disconnected control plate - two screws on either side. removed electrical leads from temp. switch and unscrewed (one screw) switch from back of control plate. replaced with new unit, reattached to plate and reconnected wires. reattached control plate to top of dryer and attached the new knob in front. plugged the dryer back in and presto! easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
  • Temperature Switch
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver
Customer: Lois from Houston, TX

The temperature switch was broken off during a recent move

First my huband remove two screw that held the front plate on..the plate came off very easy..he unplugged the broken part one wire at a time and plugged in the new wire from the new switch ..there were I believe 4 wires..it took at 2 minutes to replace the switch and maybe another minute to replace the front plate...the whole exchange took less than 5 minutes, very simple..the best part of the whole repair was that the part actually got here 3 days after we ordered it. I wasn't sure I had ordered the correct part but it was an exact match...

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-3 of 3