2033416-1-M-Whirlpool-31760602W-Infinite-Switch-Knob.jpg
2033416-1-S-Whirlpool-31760602W-Infinite-Switch-Knob.jpg 2033416-2-S-Whirlpool-31760602W-Infinite-Switch-Knob.jpg 2033416-3-S-Whirlpool-31760602W-Infinite-Switch-Knob.jpg

Infinite Switch Knob

PartSelect Number PS2033416

This infinite switch knob is two inches in diameter. It is white in color and it is made entirely of plastic. There is gray lettering denoting the varying degrees of temperature.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 1 reviews What's this?
1-1 of 1
 

4 of 6 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerJames from Prior Lake MN

Amana cooktop dual burner switch burned out

Dual Switch Amana Part # 0309550 is no longer available. Opted for this part. YOU MUST ALSO GET KSWITCH KNOB AS OLD ONE WILL NOT WORK Both burners are on but who cares. Better than spending $800 on a new cooktop. Turn off power. Push up top from underneath or carefully pry up top with screw driver. Top has sticky seal around rim so may require a little force. Put short piece of wood pieces across each corner to hold cooktop up. Remove all screws from around edge. Remove ceramic top. DO NOT TOUCH BURNERS Remove 2 scres on each end of switch panel. In order to lift out you must remove 2 screws on frame corner and 2 screws THAT hold burner support on frame. You can then lift up switch panel. Remove 2 screws holding OLD switch to panel. Remove wires from switch. MAKE SURE YOU PUT NEW WIRES IN SAME POSITION AS OLD SWITCH. Reverse to reassemble. Carefully test the burners before putting on the cooktop. Remmber to turn off power before putting on cooktop. NOTE: CHECK ORIENTATION OF SWITCH (COULD BE 180 DEGRESS) OFF. MAKE SURE KNOB OFF POSITION IS CORRECT.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1