3 of 4 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
CustomerGreg from Salt Lake City UT
Dryer made noises like metal on metal grinding
Unplugged the dryer then popped the top off and tilted it back, exposing the drum. Then using a flat bladed screw driver, removed the two sheet metal screws holding the front panel on. Once the front panel was removed, I pulled the drum off, exposing the motor and worn pulley. I removed the pulley arm, then removed the pulley. The bearings were totally gone, so I replaced it with a new pulley, replaced the belt and the front drum glides, since they were obviously worn. While it was apart, I cleaned out the interior with a shop vac, which greatly improved the efficiency of the dryer.
0 of 2 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:More than 2 hours
ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
CustomerMark from Howard Lake MN
Its good to clean all the lint out the the dryer and vents on a yearly bases as to many years of lint build up can catch on fire and make a mess . Replacing the glides was easy . Make sure you clean all the old glue , so the pads stay in place as there need to compensate for minor frame to drum differences .