Quick Question!

Have you ever purchased from PartSelect.com before?

2029830-1-S-Whirlpool-306292-Touchpad with Bracket
2029830-1-S-Whirlpool-306292-Touchpad with Bracket 2029830-2-S-Whirlpool-306292-Touchpad with Bracket 2029830-3-S-Whirlpool-306292-Touchpad with Bracket http://www.partselect.com/Schematics/Maytag/36367.gif

Touchpad with Bracket

PartSelect Number PS2029830

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At


You Save


Your Price

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 2 reviews What's this?
1-2 of 2

21 of 23 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver
Customer: Maurice from Dallas, TX

The control pad started loosing fuctions, one at a time until finally my stack unit would not even come on.

First I removed the control panel and board (which requires moving a total of 6 screws. I cleaned the board and touch padthem of the dust that had accumulated over the years and put them back to make sure that they needed to be replaced and when that didn't seem to help, I knew my options. The parts were $350.00 and although that might seem like alot.
I had watched a repairman do this 10 years earlier and saw how simple it was. To have the repairman do it, cost me over $600.00 last time.
He recommended that I replace the unit back then. This is one of the easiest repairs I've ever done. I 'd do it again, if I had to. At this rate maybe I'll get another 10 years out of my washer / dryer stack unit.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 3 people found this instruction helpful

Parts Used:
  • Touchpad with Bracket
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Patricia from St. Gabriel, LA

Washer/dryer stack wouldn't work at all.

Unit purchased new in 1984. Determined if there was primary power. checked power at transformer. there was 10vac and 26vac at four conductor plug on control board. troubleshooting guide suggested replacing touchpad. unscrewed three bolts and unplugged ribbon cable and three multiconductor plugs. replaced with new touchpad. installed in reverse order. problem solved. oringinal touchpad in unit. should last another 25 years.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2