http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/54533.gif
See part 6 in the diagram

Timer

PartSelect Number PS2021742

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $159.34
  • You Save

    $26.56
  • Your Price

    $132.78
In Stock
Order within the next 10 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 2 reviews What's this?
1-2 of 2
 

2 of 2 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerRichard from Matawan NJ

The timer on the maytag washing machine was opetating erratically and would not complete wash cycles.

First I removed 3 torx screws that hold the control panel to the top of the machine. Next I removed the timer control knob by gently pulling it off. I had to remove all the other setting knobs to release an inner panel on the control panel. Finally I removed a wiring harness from the timer and gently slid the timer off fron its mounting tabs on the inner panel. Installation was exactly the reverse. It was really a simple job.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerAllan from Milford MA

Only one of three cycles would complete properly

The opened the control panel using a Torx screwdriver(3 screws)
The timer was a sealed plastic unit.
It took a little time to figure out how to remove the knob on the front. It required the removal of a metal cover to the outer knob that was holding everything together. It would have been nice to know that a head of time. I almost broke the knobs trying to "pull" them off.
After that, I simply removed the multipin plug and installed the new unit.
One small problem that you do not want to repeat. The water level switch has a vacuum hose attached. Make sure you attach it if it falls off. Failure will result in several extra gallons of water flowing onto your floor before you realize the water didn't shut off automatically. I love learning from failure. At least the floor got cleaned.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2