79 of 112 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:More than 2 hours
ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
CustomerJohn from Spring Valley CA
No spin. Pump working. Smell of burning rubber.
I determined that the spin bearing was bad and decided to replace the brake too. Placed the machine on its side and then removed the rubber cap, v-belt, screw, drive lug and pulley. Then used a chain-vise grip to turn the brake off with the aid of a 3 foot long pipe extender for leverage. Blocked up the tub to align the transmission and installed the new spin bearing, brake, pulley and drive lug. Adjusted the drive lug position to contact the ccw motion of the pulley at the point when I could just feel the brake pressure. Installed the screw and rubber cap. Replaced the drive belts. Tested and all works. Halleluah!