Timer

PartSelect Number PS2020967

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Timer will not advance.
  • Compare At

    $152.53
  • You Save

    $25.42
  • Your Price

    $127.11
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

7 of 8 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

Customerw from phoenix AZ

Cycle would run to end but not drain

pull washer away from wall. unplug washer. check to be sure washer is unplugged. have significant other check to be sure washer is unplugged. unsnap front of cycle select knob. use needle nose to pull metal retaining clip. pull off knob and spring. pull off bottom portion of knob. check to be sure washer is unplugged. remove three phillips screws and two 1/4 hex screws from control back panel & remove back back panel. remove two 5/16 screws from front of control panel, right behind knob you removed. working behind control panel maneuver timer to remove. unplug timer. plug in new timer; plug is keyed so only goes in one way. maneuver timer back into place. tighten two 5/16 screws from front of control panel. re-install knob, spring, clip, cap. re-install rear control panel. plug back in washer. push back into place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 3 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

CustomerMike from Clear Lake IA

Timer wouldn't advance.

I replaced the timer.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerJohn from Merrillville IN

Timer was done but still had eater in the tub. My thoughts were the timer was running fast.

Took off upper back cover, after unplugging washer. Pulled center cap off knob to release the dial from the timer. Removed the dial. Removed screws that held timer. Unplugged timer from wire harness. Reversed procedilure to install new timer.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3