4 of 4 people found this instruction helpful
Level of Difficulty: Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver, Screw drivers, Wrench (Adjustable)
Customer: Gary from Chattanooga, TN
No cold fill
I checked the internet and downloaded service manual. Diagnostics took me from the cold water valve solenoid through the wiring loom to the control board. Fix was to replace board. The board is located in the control panel at the top of the machine and has a number of wires connected by push on terminals, all the terminals are slightly differant apart from the relay connections so it is difficult to get it wrong, I needed to undo two nuts and the control panel hinged forward, the circuit board is fixed by two nuts. The machine is designed to be repaired from the front if you cannot access the back covers. It means taking the front panel off which is held by four screws and two nuts which is a bit fiddly but easy with a nut driver.