BBB A-Plus

Water Valve - 4 Coil

PartSelect Number PS2020604

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Kenmore, Admiral, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

In Stock

  • Compare At

    $118.07

  • You Save

    $19.68

  • Your Price

    $98.39
Fast Shipping

Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions

Provided by PartSelect customers like you.

< PREVIOUS 1 NEXT > 1-2 of 2

 

5 of 6 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers, Socket set, Wrench(Adjustable)

CustomerSHANE from NUEVO CA

Water leaking into drum when machine is off

REMOVED THE FRONT DOOR SCREWS & FRONT PANEL SCREWS, REMOVED SCREWS IN THE "L" BRACKETS HOLDING THE TOP DOWN, TILTED THE TOP UP & BACK, REMOVED 3 HOSES & 3 WIRE CONNECTORS FROM THE OLD WATER VALVE. REMOVED 1 SCREW HOLDING VALVE & REPLACED WITH NEW VALVE. RE-CONNECTED 3 WIRES & 3 HOSES, REPLACED TOP & FRONT DOOR. WHILE THE MACHINE WAS OUT FROM THE WALL, REMOVED THE BACK LOOVERED COVER, REMOVED THE OLD BELT & REMOVED 1 BOLT HOLDING MOTOR. REMOVED TH E MOTOR, REMOVED & REPLACED THE 2 PLASTIC INSOLATORS WITH THE NEW ONES SUPPLYED WITH THE BELT ON THE MOTOR SPINDELS, RE-INSTALLED THE MOTOR & BOLT, THEN THE NEW BELT THAT IS SELF ADJUSTING. REPLACED BACK COVER & PUT MACHINE BACK ONLINE, EASY DEAL FOR ANYONE WITH VERY BASIC MECHANICAL KNOWLEDGE

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 7 people found this instruction helpful

Parts Used

    • Water Valve - 4 Coil

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver

CustomerKEITH from EVERGREEN CO

Machine would spin, but not fill

Replaced the water valve, but that was not the problem. Problem was a burned out control circuit board caused when the machine's door lock (wax motor) failed. Failure of this $20 part destroyed the circuit board ($200). Beware! Check these other items before replacing the valve.

Help other customers find the most helpful instructions.

Were these instructions helpful?

< PREVIOUS 1 NEXT > 1-2 of 2