10 of 11 people found this instruction helpful
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerJorge from Corona CA
Would not complete the "white" or "color" cycle.
Would not complete the "White" or "Color" cycle, it would get stuck on the rinse section. The only cycle that would complete was the Delicate cycle.
The Repair was quite simple. By removing the upper rear plate, you have access to all of the control and switch parts of the washer. It takes 5 screws to completely remove it.
Removing the cycle selector knob was easy too. With a screwdriver you can remove the top cap of knob. Once thats done all you do is remove the small metal clip(easy remove and replace).
Unplug the main electric connector and ground from the timer.
Once the knob is off, all you have to do is remove the 2 screws in the front(right behind the knob).
Easier than I thought for a first time.
0 of 1 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Customernick from dallas TX
Switch knob appeared stripped, wouldn't turn on
Looked at the schematic that was provided on the web site to take off the switch. Followed the basic instructions that were posted on this web site to make the repair. It was very simple