29 of 40 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:More than 2 hours
ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set
CustomerPaddy from Ferndale WA
Bearings went out in the drum.
purchased the bearings at Napa auto parts for 16$. Over all it was a little difficult to get the bearings out and back in. Used a brass drift to drive them out and to seat them back in..
1 of 2 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers, Socket set
CustomerJulio from Oviedo FL
Bad water pump and clip holding front panel
Replacing the water pump only required the removal of the front Panel, removing and replacing the pump with socket set and then installing front panel with the new clip. Once this was complete the belt drive was installed on the bottom of the washer. Very easy fix.