2020103-1-M-Whirlpool-22002162-Door-Lock-Spin-Enable-Switch.jpg
2020103-1-S-Whirlpool-22002162-Door-Lock-Spin-Enable-Switch.jpg 2020103-2-S-Whirlpool-22002162-Door-Lock-Spin-Enable-Switch.jpg 2020103-3-S-Whirlpool-22002162-Door-Lock-Spin-Enable-Switch.jpg

Door Lock/Spin Enable Switch

PartSelect Number PS2020103

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Pumps but will not spin.
  • Compare At

    $18.88
  • You Save

    $3.15
  • Your Price

    $15.73
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 1.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

45 of 58 people found this instruction helpful

Parts Used

Level of DifficultyDifficult

Time to do repair:More than 2 hours

ToolsNutdriver, Screw drivers, Socket set

Customerrichard from austin MN

Drains but doesn't spin, door lock does not engage.

Door locked light did not come on and did not have 120 VAC across the Wax Motor. Also the Wax Motor did not extend out to make contact with the Door Lock, Spin Enable Switch. General guidance is to replace drive belt and to replace Wax Motor along with the Door Lock, Spin Enable Switches (total of two limit switches). This did not correct the problem. Checked for power and traced loss of power back to the Control Board where resistor R11 was found to be burnt out. Replaced Resistor with new Carbon Film unit, rating of 3.9 K-ohms, 1/4 W and 5%. As a prcaution, replace the Triac (manufactue part number NTE5657), component identified as Q6, rating of 0.8 Amp, 600 VAC. Semiconductor parts must be obtained from somewhere other than Parts Select (unable to find in the small town I live in, I located on the internet at Mouser.com). Unit works great now.

Help other customers find the most helpful instructions.

Were these instructions helpful?

12 of 24 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers, Socket set

CustomerJames from Scotts Valley CA

Door would not lock, stopping the wash cycle

Wax motor was operational but door would not always lock. Rebuilt the latch mechanism with new parts including all three switches. Latch now makes an audible click when it engages, like it did when new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2