2019984-1-M-Whirlpool-22002023-Plastic-Washer.jpg
2019984-1-S-Whirlpool-22002023-Plastic-Washer.jpg

Plastic Washer

PartSelect Number PS2019984

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $5.52
  • You Save

    $.92
  • Your Price

    $4.60
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Spinner Support and Seal Kit

Part Number 1964673

The bolt is built into the support so if the bolt is broken, you need to replace the kit.

$118.85
In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 1.5 / 5.0, 2 reviews What's this?
1-2 of 2
 

33 of 43 people found this instruction helpful

Parts Used

Level of DifficultyVery Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)

CustomerBradley from Round Rock TX

Loud knocking during the spin cycle

Removed the Rear and Front Skins of the Washer. Removed the Belt and Tub Drive Wheel from the rear of the Tub. Removed the Front Rubber Gasket and Bracket Assy. Removed the Tub Cover w/Seal, Spinner Balance Ring (both were damaged.) Knocked the Spin Tub forward with a sharp hammer-rap on the Axle (the Axle is pressed into a Bearing that remains in the Stationery Tub.) Removed the Spinner Assy--found one of the securing bolts on the tri-Arm Support sheared off causing an imbalance. Also, the tri-Arm Support was cracked in various places. Replaced all bad parts using the Spinner Support Assy Kit and new Plastic Washers. Replaced everything else in reverse order then tested. Finally, reinstalled all Machine Skins. Very successful, about 3 hours.

Help other customers find the most helpful instructions.

Were these instructions helpful?

22 of 29 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set

CustomerPaddy from Ferndale WA

Bearings went out in the drum.

purchased the bearings at Napa auto parts for 16$. Over all it was a little difficult to get the bearings out and back in. Used a brass drift to drive them out and to seat them back in..

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2