6 of 7 people found this instruction helpful
Level of DifficultyEasy
Time to do repair:More than 2 hours
CustomerDon from Crescent City, CA
The washer would only go on the delicate cycle no matter what cycle it was set on.
This is a coin-op washer so the timer had to be removed through the coin box. The top lid was first removed from the coin box. There is one 5/16 hex head screw holding the timer in. After removing the screw the timer was lifted from the box. It is a tight fit that requires some wiggling around of the timer. There are two plug in wire harnesses attached to the timer. Because of the position of the timer the wires are a little short, but are able to be unplugged. The new timer was installed and the procedure reversed.
1 of 2 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
CustomerHAROLD from CROSSETT, AR