| |
46 of 60 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsSocket set
CustomerERIC from DUMONT NJ
Auger assembly on maytag washer was missing two agitation fins
I ordered the necessary parts which were so easy to find with Model Number of the Washer, ordered parts on a Tuesday and recieved them on a Friday!, wow was I surprised.
I simply removed the softener dispenser, used a socket set to remove single bolt and pulled broken agitator out and installed the new one after replacing the bolt.
|
4 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsSocket set
CustomerBARRY from PEACHTREE CITY GA
Free spinning agitator.
One screw off and pulled the part off. Replaced with new and put screw back in. Fabric softener snapped in place.
|
4 of 11 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerGary from Eagle Bend MN
The fins of the agitator top broke off and the screw was missing.
I decided to replace the entire agitator. The Dispenser, Agitator, and the screw had already come off when it broke. All I had to do was pull/slide the base off the motor. Then I slid the new base in place, slid the agitator on top of the base. I then screwed in the retention screw (which was probably the hardest part due to the small access). After that I snapped on the Softener Dispenser and I was done.
|
3 of 8 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsSocket set
CustomerJoshua from Sugar Land TX
Agitatir broke, dispenser clogged up.
The fabric softner dispenser just snapped on and the agitator was connected by one screw. Very easy to replace, less than five minutes.
|
0 of 1 people found this instruction helpful
Parts Used
-
- Fabric Softener Dispenser
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerDoreen from Seaford NY
Dispenser did not come with maching
All I had to do was take off the white cap on top of the spinner, place the dispenser cup in the hole and it was done! It works great even though there was no indication that my model would work with a dispenser. It was the best $3.95 I ever took a chance on!
|
0 of 3 people found this instruction helpful
Parts Used
-
- Fabric Softener Dispenser
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerCurt from Whittier CA
Fabric softener lent on washed clothing
I pried up the fabric sotener cover on top of the spindle with a screwdriver and removed it and softner cup holder-it twisted off. I then replaced entire softener unit which I had ordered.
|