2017711-1-S-Whirlpool-21001170-Motor with Pulley and Plate Assembly - 120V
2017711-1-S-Whirlpool-21001170-Motor with Pulley and Plate Assembly - 120V 2017711-2-S-Whirlpool-21001170-Motor with Pulley and Plate Assembly - 120V 2017711-3-S-Whirlpool-21001170-Motor with Pulley and Plate Assembly - 120V

Motor with Pulley and Plate Assembly - 120V

PartSelect Number PS2017711

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $270.06
  • You Save

    $45.01
  • Your Price

    $225.05
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 3 reviews What's this?
1-3 of 3
 

3 of 6 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:More than 2 hours

ToolsScrew drivers, Socket set

CustomerMark from Alamogordo NM

13 years of daily use and parts needed replaced

The repair of the four parts, motor, timer, pump and belt only took about 3.5 hours. Simply find the screws or bolts holding the part in place and undo... The place the new part back to match the holes and bolt back down... Match the wiring of the motor by moving one wire at a time. (don't pull the all off at the same time) ... And the price is wonderful... I now have a washer that will last another 10 years or more... Very easy very satisfied.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 4 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers, Socket set

CustomerCraig from Mount Shasta CA

Washer tub stopped turnig and motor made a humming sound

Removed top cover, then removed front cover. Put washer on its side and removed belt. Located motor, noted orientation of retainer wire(v shaped wire that clips motor to frame), removed motor, noted wiring diagram on paper before removing wires from termination points, removed wires. installed new motor, installed wiring, installed wire clip. Turned washer on side and installed new belt. Turned machine on and it worked great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

  • Motor with Pulley and Plate Assembly - 120V

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers, Socket set

CustomerKeith from SAINT PETERSBURG FL

Motor smoking. Occasionally stops working

Removed the front cover of the machine, held in place by 2 screws on top. Removed the ground strap secured to the motor and (2) 3/8 inch bolts holding the motor in place. Next I removed this the lower belt, pulled the motor forward, then disconnected one by one, each individual electrical connector and connected them to the new motor to assure the were connected in the proper place. After this was done, the new motor was put into place with the belt reinstalled, ground straps reconnected, and bolted back into position.
Job finished in about 20 minutes.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3