Timer

PartSelect Number PS2017539

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Timer will not advance.
  • Compare At

    $176.95
  • You Save

    $29.49
  • Your Price

    $147.46
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.3 / 5.0, 3 reviews What's this?
1-3 of 3
 

3 of 3 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

CustomerDennis from Dickinson ND

Spin cycle did not work always on the regular cycle

First I unplugged the machine to prevent me from getting electricuted.
Next I snapped the control knob cap off.
Removed clip that held knob on timer shaft.
Removed 2 inside phillips screws holding the control panel located on top.
I tilted panel forward enough to get my hand on timer.
I then used a 5/16 nut driver to remove the 2 screws attaching the timer to the panel.
Next I unplugged the wire harness.
The old timer is now ready to be discarded.
I assembled the new timer in the reverse order the old one was removed.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 2 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerGreg from Charlotte NC

Spin cycle would not work leaving clothes wet.

Replaced the timer.

I set the arrow on the dial to "off"

Hardest part was removing and reinstalling the spring-loaded plastic knob on the dial.

Popped off the central disk, dropped the retaining spring clip with a screw driver and removed the spring assembly and dial from the timer shaft, in sequence. (Repeated this process to install, after new timer was mounted).

Two top screws hold the face plate and two hex nuts hold timer in the mointing.

the timer's lectrical plug and scocket hook up was simple.

I thought calibrating the new timer could be a problem but a permanet pin in the timer shaft points to the cycle (when installed) even when the arrow knob is removed.

Greg Jones, Charlotte N.C.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 8 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers, Socket set

CustomerLinda from Crestview Hills KY

The timer was not working causing the washer to not cycle properly.

Pulled knob off timer. Removed four screws at the top of the piece holding the timer in place. Pulled the wires out of the fitting. Then reversed procedure to put back together.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3