The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Washer.
This part works with the following products:
Maytag.
Part# WP208292 replaces these:
2-8292, 208292
Customer Reviews
Average Rating:
★★★★★
★★★★★
1 Review
5.0
Filter By Rating:
5 Stars
1
4 Stars
0
3 Stars
0
2 Stars
0
1 Star
0
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
John A - 9 days ago
Verified Purchase
Easy repair
Part was exact match and was simple to install.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 4.3 / 5.0, 3 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Spin cycle would not work leaving clothes wet.
Replaced the timer.
I set the arrow on the dial to "off"
Hardest part was removing and reinstalling the spring-loaded plastic knob on the dial.
Popped off the central disk, dropped the retaining spring clip with a screw driver and removed the spring assembly and dial from the timer shaft, in sequence. (Re
... Read morepeated this process to install, after new timer was mounted).
Two top screws hold the face plate and two hex nuts hold timer in the mointing.
the timer's lectrical plug and scocket hook up was simple.
I thought calibrating the new timer could be a problem but a permanet pin in the timer shaft points to the cycle (when installed) even when the arrow knob is removed.
Greg Jones, Charlotte N.C.
Read less
Greg from Charlotte, NC
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
8 of 8 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The timer was not working causing the washer to not cycle properly.
Pulled knob off timer. Removed four screws at the top of the piece holding the timer in place. Pulled the wires out of the fitting. Then reversed procedure to put back together.
Spin cycle did not work always on the regular cycle
First I unplugged the machine to prevent me from getting electricuted. Next I snapped the control knob cap off. Removed clip that held knob on timer shaft. Removed 2 inside phillips screws holding the control panel located on top. I tilted panel forward enough to get my hand on timer. I then used a 5/16 nut drive
... Read morer to remove the 2 screws attaching the timer to the panel. Next I unplugged the wire harness. The old timer is now ready to be discarded. I assembled the new timer in the reverse order the old one was removed.
Read less
Dennis from Dickinson, ND
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers
5 of 5 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Be the first to ask our experts a question about this part!
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.