2 of 2 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
CustomerHoward from Davis CA
The shaft of the original temp selector switch was snapped off during moving.
Just remove the 2 screws out of the 4 that are on the top ends of the Control Panel. (Unplug first!)
Then lay the panel forward, remove the 1 screw holding in the temp switch, and put in the new switch.
Transfer the 4 wires (fast-ons) from the old switch to the new, and put the panel back in place, reinstall the 2 screws. Finished. Plug in & test the different settings for the correct water temp coming in throught the inlet.