2017275-1-S-Whirlpool-206216-WATER TEMP
2017275-1-S-Whirlpool-206216-WATER TEMP 2017275-2-S-Whirlpool-206216-WATER TEMP 2017275-3-S-Whirlpool-206216-WATER TEMP

WATER TEMP

PartSelect Number PS2017275

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

4 of 5 people found this instruction helpful

Parts Used

  • WATER TEMP

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers, Socket set

CustomerRobert from Aloha OR

Washer fails to fill with rinse water at end of wash cycle

First I unpluged the washer and then I removed the 4 tops screws from the washer front control panel and laid it down on top of the washer lid. I then removed the wires from the current switch and attached them to the new switch making sure they are attached to the correct push on terminals. I then removed the two screws holding the old switch, removed the old switch, seated the new switch and screwed it back in place with a socket wrench. I then put the front panel back in place and scrwed the 4 screws back in place. Took less than 15 minutes. While the switch works fine my problem is still not fixed. I had alrealy replaced the timer switch and how the temperature switch. I still need to figure out why the washer value does not open to let cold water into the tube after it finished the wash and empties the wash water.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerJon from Punta Gorda FL

Washer shutting down with cold/cold temperature selection

Reading some information on-line of what could be the problem, started with removal of water in-let hoses checking the inside filter screen on the Water Inlet Valve, it was clogged, removed valve cleaning screens as best as could. Used low pressure air to blow out also. Replaced with some success of washer operation but not complete. The water temperature switch worked on warm(water was hot) and hot for wash but would not operate rinse with cold water. Replaced both valve and switch the washer works good once more, no problems with water temperature selection. Decided to replace both water feed hoses while having the washer away from the wall. Thought purchase of replacement parts to be a good investment.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 3 people found this instruction helpful

Parts Used

  • WATER TEMP

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerShirley from Las Vegas NV

Broken water temperature switch

The hot water select broke. The item was easy to find and order on your site. The part was easy to install. Will order from you again if parts are needed.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3