2016361-1-S-Whirlpool-200835-Brake Rotor Bearing
2016361-1-S-Whirlpool-200835-Brake Rotor Bearing 2016361-2-S-Whirlpool-200835-Brake Rotor Bearing 2016361-3-S-Whirlpool-200835-Brake Rotor Bearing

Brake Rotor Bearing

PartSelect Number PS2016361

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Unusual Noise.
  • Compare At

    $15.98
  • You Save

    $2.66
  • Your Price

    $13.32
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.0 / 5.0, 2 reviews What's this?
1-2 of 2
 

64 of 91 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)

CustomerJohn from Spring Valley CA

No spin. Pump working. Smell of burning rubber.

I determined that the spin bearing was bad and decided to replace the brake too. Placed the machine on its side and then removed the rubber cap, v-belt, screw, drive lug and pulley. Then used a chain-vise grip to turn the brake off with the aid of a 3 foot long pipe extender for leverage. Blocked up the tub to align the transmission and installed the new spin bearing, brake, pulley and drive lug. Adjusted the drive lug position to contact the ccw motion of the pulley at the point when I could just feel the brake pressure. Installed the screw and rubber cap. Replaced the drive belts. Tested and all works. Halleluah!

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 12 people found this instruction helpful

Parts Used

  • Brake Rotor Bearing

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Screw drivers

CustomerCarl from Hollis NH

Weak agitation cycle

Agitation cycle was rather weak, and wife reported a strange sound and smell (burning belt). Replaced the drive belt (no better behavior). Removed the drive pulley, checked the bearing (with all the grease removed, definite clicking when spinning the bearing). Replaced the bearing. (still no better behavior). Took off the motor and cleaned the mount, including re-lubricating with silicone grease, and checked the springs. (still no better behavior). Did some research online and took a closer look at the drive pulley lug. It seems that I put the lug back incorrectly, forcing the pulley up too tightly so it could not spin back down the shaft. Once I put it back on correctly (I think), the agitation problem seemed to be fixed. So, it is likely that replacing the drive belt and/or bearing solved the problem, but that was masked due to my putting the lug on incorrectly. DIYers beware.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2