http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/24999.gif
See part 63 in the diagram

Freezer Door Gasket - Black

PartSelect Number PS2007694

This door gasket is used to seal the freezer door when closed.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $110.48
  • You Save

    $18.41
  • Your Price

    $92.07
In Stock
Order within the next 14 mins and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.6 / 5.0, 2 reviews What's this?
1-2 of 2
 

3 of 4 people found this instruction helpful

Parts Used

  • Freezer Door Gasket - Black

Level of DifficultyEasy

Time to do repair:More than 2 hours

ToolsNutdriver

CustomerClifford from Lincolnville ME

Freezer door gasket leaking

Remove small 1/4 inch hex head screws around inner perimeter of door. You have to hold the gasket back to access them. The entire molded door liner/shelf comes off with the gasket. It took a little while to de-ice the fiberglass insulation that tucked into the door liner (the ice was a result of the leaking gasket). De-icing was achieved with first a heat gun to allow removal, then placed in the oven for a couple hours at 300F to melt and evaporate the moisture from the insulation. I also needed the heat gun to straighten/relax the new gasket, as it had taken on a permanent crumple from being stored in a smaller than actual sized box. Instructions to smooth the new gasket were included with the box. Finally, fit the new gasket around the perimeter of the door liner and re-install the door panel with the 1/4 inch hex screws.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 4 people found this instruction helpful

Parts Used

  • Freezer Door Gasket - Black

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerDavid from San Rafael CA

Gasket not sealing

removed screws holding original gasket. removed gasket. placed new gasket on door and replaced screws. A little tricky getting new gasket in position before screws. patience!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2