2004037-2-S-Whirlpool-12002750-Rear Convertible Tine Kit
2004037-2-S-Whirlpool-12002750-Rear Convertible Tine Kit 2004037-1-S-Whirlpool-12002750-Rear Convertible Tine Kit 2004037-3-S-Whirlpool-12002750-Rear Convertible Tine Kit

Rear Convertible Tine Kit

PartSelect Number PS2004037

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $45.62
  • You Save

    $7.60
  • Your Price

    $38.02
In Stock
Order within the next 7 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

11 of 16 people found this instruction helpful

Parts Used

  • Rear Convertible Tine Kit

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerDonna from Grand Ledge MI

The vinyl coating on the forward rack of convertible tines dried and cracked away, allowing the steel underneath to rust and deteriorate. It eventually just broke.

After looking the situation over, I decided to remove the entire lower rack and place it on the counter where I could see better. I specified I needed the front tine (part # 24), but received both front and back tines). I used the screwdriver to help slip the old piece out of the plastic clamp end. I broke the end of the first clamp, but fortunately, replacement clamps were also included in the kit. I decided it would be easier to assemble the tines and the clamps first, and then install that into the rack, so I had to remove the other plastic clamp and did so successfully. Then holding the assemblage in place to see just where to snap it into place, I proceeded one clamp at a time and installed it. I kept the new back tine guide just in case someday that one wears out too.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 9 people found this instruction helpful

Parts Used

  • Rear Convertible Tine Kit

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerSteven from Abingdon MD

The front set of convertible tines had begun to rust.

Snapped the old, rusting, tines out of the clips and snapped the new, not yet rusting, tines in. Although the kit includes both sets of tines and replacement clips, I only replaced the one part.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 8 people found this instruction helpful

Parts Used

  • Rear Convertible Tine Kit

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerPatricia from Nebraska City NE

Tines were rusting

I pulled the set of tines that hold the plates off the clips that hold them and pushed the new set into the clips. It was done!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3