Injector Valve Kit

I took off the front of machine by taking out the two screws at bottom of front panel. As I turned the water off and on I could see the leak coming from the sleeve bracket area. Using a small socket I was able to loosen the screw and pull apart the hose from the valve and replace with the new valve in about 30 seconds. Tightened everything back up, turned on the water again--all dry! Put panel back on and good as new!

Watched video at partselect.com on how to replace injector valve. Followed instruction and used parts in kit to complete repair in less than 30 minutes. Leak stopped and washer runs perfectly.

I opened the front of cabinet (2 philips screws at bottom corner with short screwdriver. Then took out 2 cap screws that hold top on with a 3/8" deep socket and ratchet. Once in, I removed the 3 hose clamps that hold the injector and hose in place and removed both pieces. I put the injector together and put it in and clamped it back in. I put the the seal on the tub end of the hose and installed it in the tub, then clamped the other end again. I ordered the seal separate but I wouldn't have had to since one was included with the injector hose. I reused my old hose clamps since they were in good shape. With that I closed up in reverse order. I could have gotten the parts cheaper from another online souce that I found later. Other than that, PartSelect worked great.