Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2003093
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
Before I give procedure steps, please note the following observations that I had.a)If AC power is plugged in and an electrical terminal touches the frame, the resulting arc may require that you reset the GFCI or the circuit breaker.b)The clock failed to run until it was properly mounted (including the back cover in place).c)Movement of wires can cause them to work loose at EITHER end of the wire.d)Attempting to operate the clock, Start and Stop knobs may extremely difficult or otherwise ineffective unless it is properly mounted. Fully depressing these knobs / shafts is difficult. The numbered steps below are how I would do it correctly based on what i learned.1)I unplugged gas range power cord.2)Re-positioned range to access the back without damaging the flexible gas supply line.3)Removed the rear cover (#2 Philips) behind the timer. 4)Verified no voltages present5)Judged that the front cover glass needed removal - removed timer knobs and front glass cover6)Removed existing clock timer by using a WIDE flat blade screwdriver to depress the rear of each clip and pushing the time our the front. Old part has damaged gears and one axle end out of position.7)Fed old timer back through the opening to the rear to assist with transfer of wires.8)With the assistance of a helper, transferred the wires one at a time from the old to the new timer.9)Fed new timer back through the opening to the front; aligned and snapped into place.10)Replaced front glass and knobs.11)Plugged in AC cord (first did inspection for snug connections and potential shorts). 12)Tested buzzer feature of the timer. Unexpected that the buzzer was intermittent.13)Unplugged power cord. Found & tightened loose connection - not at timer but other end of one of the timer wires at the chassis connection strip.14)Reinstalled the metal back cover & plugged in the AC cord.15)Set the timer start and stop times to one hour before present time. (Knobs need to be depressed.)16)Set clock to present time by depressing the knob IN and rotating it clockwise to the correct time. As clock is manually advanced to the timer start and stop times, verified that each knob popped out. The hand on the clock for the timer moves also, but when you release the knob pressure, the knob pops out and then you set the timer past the buzzing to zero.18)I put the oven through a self-cleaning cycle. This uses the new timer; starts when the START button pups out and stops when the STOP button pops out. Of course there are other controls you need to manipulate for the self-cleaning cycle i.e. CLEAN settings and the door lock.
Help other customers find the most helpful instructions.
Were these instructions helpful?
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.