Dispenser Crusher Motor

PartSelect Number PS1993877

This motor is used to activate the blades to crush the ice for dispensing.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Ice maker won’t dispense ice.
  • Compare At

    $121.22
  • You Save

    $20.20
  • Your Price

    $101.02
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.0 / 5.0, 3 reviews What's this?
1-3 of 3
 

10 of 14 people found this instruction helpful

Parts Used

  • Dispenser Crusher Motor

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers, Socket set

Customerjohn from montgomery TX

Ice would not dispense

I removed 6 screws, unplugged assembly that had motor attached,removed from fridg,replaced motor and reinstalled assembly, putting back 6 screws.works like new.
thanks.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 6 people found this instruction helpful

Parts Used

  • Dispenser Crusher Motor

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers, Socket set

CustomerBrian from Battle Ground WA

Ice crusher not working

Remove the ice maker, motor and replace.

The biggest problem was that the part was NOT available from GE. Part Select had the part, it was easily identified on their website and it couldn't have been easier to order it.

The repair from GE would have cost me hundreds of dollars. Thanks Parts Select.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 10 people found this instruction helpful

Parts Used

  • Dispenser Crusher Motor

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsPliers, Socket set, Wrench(Adjustable)

CustomerEleanore from Setauket NY

Motor was not working

Actually, a friend did it with me watching. He took out about 6 screws, removed the back plate and the old motor and installed the new motor when he realized the hole on the plate that goes in front of the motor was on the wrong side! This would have been a snap and done in about 30 minutes if it wasn't for the hole on the wrong side. So he drilled a hole on the correct side of the plate, using the old plate as a pattern, and it works fine!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3