Oven Thermostat with Flange

PartSelect Number PS1736167

This temperature sensor detects the temperature within the oven cavity.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.5 / 5.0, 2 reviews What's this?
1-2 of 2
 

4 of 10 people found this instruction helpful

Parts Used

  • Oven Thermostat with Flange

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsSocket set, Wrench(Adjustable)

CustomerJohn from Angleton TX

Thermoset w/flange , for the oven

THE FUEL LINES HAD TO BE CROSS OVER FROM THE FACTORY POSITIONS WHICH MADE ONE 3/8" TO SHORT. RESOLVED PROBLEM BY CUTTING THE SHEET METAL ON THE BACK OF THE STOVE TOP FROM 1" HOLE TO 1.5" BY CUTTING A SLOT IN THE LOWER PROTION OF THE HOLE WHICH WHEN BENT DOWN ALLOWED ME TO REBEND THE FUEL LINE DOWN GIVING ME THE NEEDED LENGTH TO RECONNECT THE FUEL LINE. NEW THERMOSET/FUEL VALVE WORK GREAT UPON COMPLETION. SINCERELY JOHN O.BEVERS

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 11 people found this instruction helpful

Parts Used

  • Oven Thermostat with Flange

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers, Wrench(Adjustable)

CustomerDan from Caseville MI

Oven would light but not shut off at designated temp

Make sure that gas is turned offf to appliance.I had to remove the top of the range and use adjustable wrench to loosen the two gas tubes. Then use screww driver to remove valve from gas feed tube ( oh - make sure to turn of gas at apppliance gas valve). I then had to use the adjustable wrnech for removing the flange.

Caution should be used when reinstalling the tubing. Also test all jionts with soapy water.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2