Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/Maytag/22591.gif
See part 411 in the diagram
http://www.partselect.com/Schematics/Maytag/22591.gif

USE ACP D8547912

PartSelect Number PS173554

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.5 / 5.0, 2 reviews What's this?
1-2 of 2
 

29 of 38 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Pliers, Screw drivers
Customer: Jay from Edwardsville, IL

Blows main fuse when the microwave generator start, (cooking function).

Remove microwave from oven cabinet. remove cover and check main fuse with ohm meter.
Tried fuse, it does not blow untill cooking starts.
Check capacitor with ohm meter, after properly performing capacitor dischagre procedure.
Order new capacitor, simple installation. another new fuse and all is good and cooking again.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 4 people found this instruction helpful

Parts Used:
  • USE ACP D8547912
Level of Difficulty: A Bit Difficult
Time to do repair: 1- 2 hours
Tools: Screw drivers
Customer: Roger from Fort Worth, TX

The microwave would blow the fuse immediately when trying to use.

I replaced the large capacitor (.95 uf). Much of the shell (casing) has to be removed and the capacitor is hard to get to. It is housed in a very inconvenient place. Because of the unfamiliarity of how to access the capacitor it took about an hour to get to it. After receiving the new capacitor it only took about half an hour to install it, re-assemble the microwave, and re-install under the cabinet. Of course a new fuse was required.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2