| |
13 of 14 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
Customerkeith from sarasota FL
Compressor not cycling on/compressor not pumping refrigerant
Using a nut driver I removed the lower back panel to gain access to the compressor.Removed a clip that held Run Capacitor and Overload Relay in place on the compressor.I removed the capacitor first then pulled the relay off from the compressor.Then I unplugged the wire harness from the relay.This job is very simple if you have original replacement parts in hand to re-install.PartSelect provided me with the exact replacement parts...
Update: My refrigerator has been running 6 weeks now.Soon after I sent the note above I had a Technician check for refrigerant in the system.There was none!The Technician,who replaced my evaporator-heater in November failed to plug properly the port on the compressor.So,this thing is now running better than before.It now makes ice in the same container at the same setting,in 6 hours instead of 8 hours.
|
4 of 4 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsNutdriver, Pliers
CustomerCharles from Knoxville TN
Quit cooling ,had a click noise when it tryed to turn on compressor
removed the rear panel and replaced the part on the compressor and replugged the wires.Easy!
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers
CustomerGary from Franklin NE
Refrigerator suddenly quit
I took off the back and unsnaped the old relay and pluged in the new one.The part was recieved really fast.
|