Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS1595603
This part helps determines the dryness of the clothes to reduce over – drying.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
1: (Automatic Dry Sensor) Removed 2 screws holding front panel, then removed 2 screws holding automatic dry sensor to inside of tub. Disconnected 2 wires from under side of sensor and removed sensor. Placed new sensor in place, reconnected wires, and reinstalled 2 screws. Finally, put cover in position and secured with 2 screws.2: (Pilot Lamp) Removed 2 screws at bottom of washer front panel. Pulled bottom of front panel forward and removed from unit. Pulled lamp socket from clip, replaced bulb, and replaced lamp socket in clip. Reattached front cover.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Unplugged the dryer (electric), removed two screws at bottom of front panel and removed front panel. Pulled electrical clips from sensor lugs near center.front of drum exterior. Located sensor inside front of drum interior, removed screw at each end. Removed old sensor, placed new sensor in position, attached with screws. Installed electrical clips on lugs, closed front panel and secured with two screws. Plugged in the dryer and it worked!
Disconnected dryer, took off front, took off screen housing, took belt off pulley and lifted out tub. Removed snap rings from roller shaft and removed rollers. Then removed roller shafts. Reversed procedure and added new shafts, rollers, washers, nuts and snap rings. Put tub in and put belt on pulley. Replaced auto dry sensor before replacing lint screen housing and connected wiring. Put front on and connented dryer. Be very careful when working with roller shafts. My wrench slipped and I ended up with 8 stitches in my right hand. The sheetmetal is sharp!
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.