| |
12 of 23 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:1- 2 hours
ToolsNutdriver, Pliers, Screw drivers, Wrench set
CustomerMICHAEL from WHITEFIELD ME
Water dispenser
I put in all new limit switchs. and put in a new water&icemaker valve. now it works great.
|
4 of 7 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerPablo from Whittier CA
Ice/water switch burned out
The ice maker and water dispenser alway stayed on running it would not shut off automaticlly. i had to shut the power, so i took the front pannel ot were you put the cup in and notice the switch the pushes in and out did not go out it was on the pushed in and the clips were they are pluged inwere burned out so i took the switch off and lokked it up on this site and found exaccly what i needed.
|
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerMichael from Kutztown PA
Ice dispense would stick in on position
Remove the slide-in tray. Remove just the 2 bottom screws of the panel, and slide the panel up to release the top. While suporting the panel, unplug the cable that goes to the PC board in the panel. Remove 3 screws that hold the assembly with ice and water dispenser actuator pad and switch and pull down and out. ( make note how the water tupe is routed for re-assembly) While supporting the assembly disconnect the 2 cables to the assembly. Replace the switch and actuator pad and reassemble. ( make sure the water tube is in the correct position).
|