1526364-2-S-Frigidaire-241680002         -Ribbon Cable Harness
1526364-2-S-Frigidaire-241680002         -Ribbon Cable Harness 1526364-1-S-Frigidaire-241680002         -Ribbon Cable Harness

Ribbon Cable Harness

PartSelect Number PS1526364

Used in the dispenser board area.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Water dispenser will not dispense water.
  • Ice maker won’t dispense ice.
  • Compare At

    $13.99
  • You Save

    $2.33
  • Your Price

    $11.66
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.6 / 5.0, 4 reviews What's this?
1-4 of 4
 

26 of 47 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerMike from Mantua NJ

Replace the ribbon cable for the water/ice dispenser

I replaced the paddle for the water dispenser in the refrigerator and in that process the ribbon cable shorted out from the bending and the electricity did not go through so I ordered a new
ribbon cable which was easy to install.

Help other customers find the most helpful instructions.

Were these instructions helpful?

15 of 25 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsPliers, Screw drivers

CustomerGary from Floresville TX

I had had a repairman look at the problem, and he estimated the cost of the repair to be $225 to $500. Needless to say I was quite happy that I was able to do it myself for $85.

I found that getting the water/ice dispenser back in place was the hardest part because the water hose is so short. I finally threaded a stiff wire up into the hose and guided it through the dispenser opening. The rest was pretty much routine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

14 of 23 people found this instruction helpful

Parts Used

  • Ribbon Cable Harness

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerCarmelo from Howell NJ

No power to ice and water dispenser

First removed the drip tray with a firm tug, Then removed the 2 screws to remove the trim, had to remove the board to get get to the connector. (there is a clip that holds the wire tight) connected the new ribbon cable and secured it with the clip, screwed the board back in and pushed in the other end of the cable. and screwed the trim back and the drip tray. surprisingly Very easy to do.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 16 people found this instruction helpful

Parts Used

  • Ribbon Cable Harness

Level of DifficultyDifficult

Time to do repair:1- 2 hours

ToolsScrew drivers

CustomerThelma from Hickory NC

Husband pushed water to hard and though it was the ice maker

Just pluged it in

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4