Quick Question!

Have you ever purchased from PartSelect.com before?

1526364-2-S-Frigidaire-241680002         -Ribbon Cable Harness
1526364-2-S-Frigidaire-241680002         -Ribbon Cable Harness 1526364-1-S-Frigidaire-241680002         -Ribbon Cable Harness http://www.partselect.com/Schematics/Frigidaire/O12QQKWZ.gif

Ribbon Cable Harness

PartSelect Number PS1526364

Used in the dispenser board area.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Not dispensing water.
  • Ice maker won’t dispense ice.
  • Light not working.
  • Ice maker not making ice.

Compare At

$16.20

You Save

$2.70

Your Price

$13.50
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.6 / 5.0, 4 reviews What's this?
1-4 of 4
 

35 of 66 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Screw drivers
Customer: Mike from Mantua, NJ

Replace the ribbon cable for the water/ice dispenser

I replaced the paddle for the water dispenser in the refrigerator and in that process the ribbon cable shorted out from the bending and the electricity did not go through so I ordered a new
ribbon cable which was easy to install.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

20 of 32 people found this instruction helpful

Parts Used:
  • Ribbon Cable Harness
Level of Difficulty: Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers
Customer: Carmelo from Howell, NJ

No power to ice and water dispenser

First removed the drip tray with a firm tug, Then removed the 2 screws to remove the trim, had to remove the board to get get to the connector. (there is a clip that holds the wire tight) connected the new ribbon cable and secured it with the clip, screwed the board back in and pushed in the other end of the cable. and screwed the trim back and the drip tray. surprisingly Very easy to do.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

17 of 29 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 1- 2 hours
Tools: Pliers, Screw drivers
Customer: Gary from Floresville, TX

I had had a repairman look at the problem, and he estimated the cost of the repair to be $225 to $500. Needless to say I was quite happy that I was able to do it myself for $85.

I found that getting the water/ice dispenser back in place was the hardest part because the water hose is so short. I finally threaded a stiff wire up into the hose and guided it through the dispenser opening. The rest was pretty much routine.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 19 people found this instruction helpful

Parts Used:
  • Ribbon Cable Harness
Level of Difficulty: Difficult
Time to do repair: 1- 2 hours
Tools: Screw drivers
Customer: Thelma from Hickory, NC

Husband pushed water to hard and though it was the ice maker

Just pluged it in

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-4 of 4