| |
18 of 31 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerMike from Mantua NJ
Replace the ribbon cable for the water/ice dispenser
I replaced the paddle for the water dispenser in the refrigerator and in that process the ribbon cable shorted out from the bending and the electricity did not go through so I ordered a new
ribbon cable which was easy to install.
|
11 of 16 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:1- 2 hours
ToolsPliers, Screw drivers
CustomerGary from Floresville TX
I had had a repairman look at the problem, and he estimated the cost of the repair to be $225 to $500. Needless to say I was quite happy that I was able to do it myself for $85.
I found that getting the water/ice dispenser back in place was the hardest part because the water hose is so short. I finally threaded a stiff wire up into the hose and guided it through the dispenser opening. The rest was pretty much routine.
|
11 of 17 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerCarmelo from Howell NJ
No power to ice and water dispenser
First removed the drip tray with a firm tug, Then removed the 2 screws to remove the trim, had to remove the board to get get to the connector. (there is a clip that holds the wire tight) connected the new ribbon cable and secured it with the clip, screwed the board back in and pushed in the other end of the cable. and screwed the trim back and the drip tray. surprisingly Very easy to do.
|
3 of 10 people found this instruction helpful
Parts Used
Level of DifficultyDifficult
Time to do repair:1- 2 hours
ToolsScrew drivers
CustomerThelma from Hickory NC
Husband pushed water to hard and though it was the ice maker
|