78 of 140 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
Customertom from Ridgefield CT
Replace timer and knob
removed back panel, exchanged wires on old timer to new. Do this one at a time as there is no color chart to follow. Timer clips back in. Used a little screw to lock it in. Not sure if this was on the original but there was a place for it. Re-attached back panel and placed knob on shaft.
Overall saved a bundle as a service visit is $175.
2 of 5 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
CustomerJennifer from Midland TX
Plastic shaft broke
My husband un-screwed a few screws to take the cover off then just rewired the new timer and put the cover back on. I actually had an easier experience with this website than the actual GE website, which I used prior to partselect, and ordered the wrong part. Thanks and I will definately refer and use this site again. AWESOME!!