| |
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerCarvel from Buies Creek NC
Control knob teeth worn down causing knob to spin without engaging
Removed retainer clip behind control knob with pliers {neddle nose} knob pulls off, slide new knob on with retainer clip,all set to go.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerWilliam from Garnet Valley PA
Control knob would not select function desired
REMOVED RETAINING CLIP FOR KNOB AND REMOVED KNOB. INSTALLED NEW KNOB AND CLIP. THATS IT, EVERYTHING WORKS AS REQIRED.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerKaren from Harvey LA
Control knob had broken
It was very easy to fix the problem with the new control knob. Watched a short video explaining how to remove old one and it worked.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerPhilip from BUtler PA
Teeth on knob were worn off.
Removed plastic pin holding knob with long nose pliers. Pulled off knob & replaced with new unit.
The delivery service was the fastest I have ever experienced.
Thank You
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerScott from Fresno CA
Timer would not turn
used pliers to pull off clip then poped on new knob very easy
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerJohn from Hardin KY
I had a striped knob
I just pushed the new knob on the shaft and was done
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
Customertommy from springhill FL
Knob was broke
I took a pair of pliers removed the clip and pushed the new one on. Easy fix .
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerBetty Sue from Antioch TN
Knob would not engage to select a cycle to begin a wash..
Fortunately I was able to use the machine while my part was being sent, by manually making my selection with the outer dial, When I found my part that I needed to purchase, I watched the video for repair. It showed me how easy it was to change out the part and have my machine back in proper working order. This is the second time I have been able to use this website to repair an appliance.
|