http://www.partselect.com/Schematics/GE/GE_Thumb/00123074i02.gif
See part 323 in the diagram

Igniter Harness Switch

PartSelect Number PS1481008

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $106.86
  • You Save

    $17.81
  • Your Price

    $89.05
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.3 / 5.0, 1 reviews What's this?
1-1 of 1
 

30 of 39 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsPliers, Screw drivers, Wrench(Adjustable)

CustomerFRANK from MEMPHIS TN

The cooktop had a shorted out burner control.

Unpllug the cooktop and turn off the gas supply. Remove the grates and burners.(they just lift out). Using a torx screwdriver, remove all the torx screws below where the burners sit. There are three screws per burner, except the power burner which has only two screws. Genly lift the stainless steel cooktop, separating it from the rest of the enclosure. Hold the electrodes with one hand, while gently twisting and pulling the wire connector off. Now, remove the aluminum covered foam piece. You will now have acess to the wiring harness assembly. Disconnect the quick connectors and replace with the new assembly. Re-assemble in the reverse order and you're done. About 1.5 to 2 hours. Good Luck

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1