Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11770483
This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.
This part fixes the following symptoms:
Unscrewed the housing for the old piece and screwed on the new part. No tools needed. Easy to use website, fast delivery. Very easy.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Arm screwed on and immediately fixed the problem.
I unscrewed the housing for the spray arm and screwed in the new housing and spray are part. It took less than a minute and works perfectly.
Easiest repair ever. The spray arm itself usually really is not the problem, it usually is the clip or gasket that holds the spray arm on. It wears out. This part is perfect for it supplies a new spray arm, nut and gasket/clip. I think it wears out due to a build up on the arm that puts too much pressure on the clip/gasket. Remember when taking the nut off, if you are standing above the unit with your arm inside, you turn the nut clockwise while looking down. Good luck.
VERY simple repair - just unscrew the retaining nut by hand and hand screw on the new spray arm and nut assembly. A 30 second fix!
This part fixed problem. The original part seemed to have a defect. Was simple to fix, simply took off old piece still connected and hand tighten the new piece on, it took about 30 seconds.
Just unscrew old one and screw in the new one Very Easy
The new arm came preassembled. I unscrewed the old arm base with my hand and screwed the new arm in place. The whole process took less than a minute. The new part was not made the same way. It was better than the original. Must have been a problem from the manufacturer. WORKS GREAT!!!
The spray arm is attached to a part that is screwed on. The new part came completely assembled. I unscrewed the old spray arm and then screwed the new part on. Less than 15 minutes. Works great!
removed clips holding upper rack and pulled out. Simply screwed new sprayer arm in place. Replaced upper rack on track & popped clips in.
It simply unscrewed and screwed back in in less than 3 minutes
Very simple repair - in my case part of the upper spray arm broke off, leaving the threaded portion still in the dishwasher. Just unscrewed the remaining broken part, and screwed back in the new part.
Removed the old spray arm by unscrewing it from the top inside of the dishwasher. Then screwed on the new spray arm. Could not have been any easier and it has not fallen off since.
Unscrewed the mounting nut and the assembly came off . A simple task of taking the new assembly and screwing it back on .
I replaced the top spray arm and the bottom spray arm. The middle one looked like it could use replacement but it wasn't an available part. Dishes come out clean again. I didn't need any tools to install or remove the old spray arms.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.